How it works

Ok. Here’s the deal. No fancy instructions. No tools needed. It’s a bunch of pieces of foam. Probably self explanatory, but here goes…

The Savvy Lab Toy Blocker foam has been custom cut for use on a variety of furniture types and heights.

Take your piece of foam and decide which direction it should fit under your furniture. Remember, the foam should be taller than the height of the gap.

Squeeze the foam and slide it under your furniture piece, pushing it back under the furniture until it cannot be seen from the room. Usually about 1 - 1.5 inches. The foam should provide a tight compression fit between the bottom of your furniture and the floor.

You can set your foam blocks side to side to adjust to any length furniture you have. Or you can stack them to provide tighter compression if your furniture is unusually high.

The possibilities are endless! Ok, probably not endless. Probably only 6 or 8 possible configurations to accommodate virtually any furniture piece. But the choice is yours!

That’s it. I wish I could try to make it sound more complicated. But it’s not. Squeeze, fit, forget. It’s that simple.